DSFIREFLY-4 March 08
?008 REG No 277 4001, ENGLAND.
Page 4
FIREFLY
FIREBLADE
RADIO REMOTE CONTROL SYSTEMS
To learn a new transmitter switch follow this procedure
Any transmitter button can be learnt to one or many of the receiver output relays.
Each button must be learnt to each relay individually by following this procedure:
1. To select the receiver output relay to learn to:
a. Briefly press the receiver Learn switch (SW1) once
b. The Learn LED will flash once to indicate output relay 1 is selected
c. After the LED stops flashing, press the Learn switch again to select the next relay channel
d. Repeat step c until the required output relay is selected.
2. Press the button on the transmitter you want to learn to the relay output.
3. The Learn LED will then illuminate, press the same transmitter button again.
4. The Learn LED will then flash to indicate learning is complete.
5. To test the operation, press the transmitter button again and you will hear the relay click as it operates.
Erasing Receivers Memory
1. Press and hold the receiver Learn Switch for approx 10 seconds.
2. When the Learn LED turns OFF all memory is erased
3. This is factory default state which is indicated by all output LEDs flashing together.
NOTE: You cannot erase individual Tx encoders
Receiver Outputs
The jumper links configure the outputs to be Momentary, Latching or Timed.
The jumper links are made / removed by a small link cap placed over the pin header.
Jumper Links
(LK2 - 4)
Outputs 2 - 4
Open
Mom (The Output operates for as long as the transmitter switch is held on)
Connected
Latch (The Output changes state each time the Transmitter is operated)
LK0
LK1
Relay Output 1 Only
Open
Open
Momentary
Open
Connected
Output 1 Latching
Connected
Open
Fixed to ?Second Momentary o/p
Connected
Connected
Output 1, 0 to 5 minutes using Timer selection Potentiometer.
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
FLA01.07.0045A
ANT 5-BAND FLEX PCB W/CABLE
FPC-532-DC
POWER CABLE FUSED DC
FW.90.SMA.M
RF ANTENNA
FXP07.07.0100A
ANT 5-BAND FLEX PCB W/CABLE
FXP07.09.0100A
ANT 5-BAND FLEX PCB W/CABLE
FXP100.07.0100A
ANT WIDE-BAND WIMAX FLEX PCB
FXP14.07.0100A
ANT 6-BAND FLEX PCB W/CABLE
FXP14.09.0100A
ANT 6-BAND FLEX PCB W/CABLE
相关代理商/技术参数
FIREFOX386SX-CHIPSET
制造商:未知厂家 制造商全称:未知厂家 功能描述:Microprocessor
FIREWIRE CARDS KIT-HELICOS
制造商:Portwell 功能描述:PORTWELL I/O AND IMAGING - Bulk
FIRMWARE
制造商:CSR 功能描述:
FIR-PARA-XP-N1
功能描述:开发软件 FIR Filter Parallel RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
FIR-S-31-SC-A
制造商:Finisar Corporation 功能描述:RECEPTACLE ISOLATOR,LF,1310NM,0.5 X 0.5MM - Bulk 制造商:Finisar Corporation 功能描述:ICOLATOR RECEPTACLE 1310NM
FIR-S-55-SC-A
制造商:Finisar Corporation 功能描述:RECEPTACLE ISOLATOR,LF,1550NM,0.5 X 0.5MM - Bulk 制造商:Finisar Corporation 功能描述:ICOLATOR RECEPTACLE 1550NM
FIRS5M30JCKCCE
制造商:TE Connectivity 功能描述:RTANG JACK W/MTG PINS,BNC PCB,HAZMAT - Rail/Tube
FIR-SER-XP-N1
功能描述:开发软件 FIR Filter Serial RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors